Call us to get tree help like tree clean, tree removal, bush haul, shrub disposal, stump grind and a lot of others in United States.


Call now

Call us +1 (855) 280-15-30










Login now.

This item: Streetside Tools SST - GM,R Extension Housing Bushing Driver/Installer and Removal Transmission Tool/KitOnly 4 left in stock - order soon/5(12). Stump grinder ebay australia, 28801 Asheville NC 15, Discussion Starter #1 May 14, Need to remove the tailshaft bushing on a Nash 4+1 trans without removing the trans from the car. Looking to buy/rent the bushing removal tool (Snap on # S).

Anyone have any leads on getting this tool or any other way of removing the bushing. Note this trans uses the large bushing (just under 2 Estimated Reading Time: 1 min. Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car. Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools.

The tail shaft bushing is a regular wear item, located inside the transmission tail shaft housing. It should be replaced when replacing a tail shaft seal or when a driveshaft failure has occurred.

A worn bushing will cause excessive side-to-side movement of the slip yoke and create a Reviews: Apr 30, Bloomington, MN. KD Tools makes a tool for this.

(#) (Don't know if it's still available or not. I got one on ebay years ago.) You can use it to pull and replace the tail shaft bushing. Makes it a 5 minute job. maverick said: place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is.

Jul 18, 2, Posts. #3 Jul 16, There is a tool, all new cars use it today. Or just remove the tail shaft housing but hold the mid plate and don't.

make it move at all or you'll lose all the input shaft needle bearings. You will need to disengage reverse gear fork. B. Apr 10, I need to replace the bushing in the tailshaft of my T-5 as I have a leaky seal and vibrations. I'm not quite skilled enough yet to drop the transmission and take the tailshaft off, and no show near me had the tool. They all just want to do a full rebuild.

Does anyone have this tool? I would be willing to pay shipping and throw 30 bucks your way. Jun 14, The seal im going to replace and should be no problem but i am taking about the bushing that sits behind the seal. That one either i take off the rear part of the transmission and take it to a machine shop so they can replace the bushing, or i read that with one of those special tools you can remove the bushing and insert a new one without removing part of the Estimated Reading Time: 11 mins.

Nov 06, anyone replaced the E4OD tail shaft bushing? this is the long bushing that the front of the drive shaft rides in in side the trans. I think mine is worn out and allowing the front yolk to wobble causing a vibration fom about 50 up to around i know the tail will come off the trans body easy, but getting that bushing pressed out may be a problem.

Oct 25, (2) Remove the bolts holding the tailshaft housing in place. (3) Remove the sidecover, exposing the gears (4) Turn the tailhousing so the bottom is facing the open side cover. You should be able to see the c-clip in question. Use a c-clip tool to expand the c-clip. With the clip expanded (even slightly) the tailshaft housing should slide right out.