Call us to get tree help like tree clean, tree removal, bush haul, shrub disposal, stump grind and a lot of others in United States.


Call now

Call us +1 (855) 280-15-30










This is a tapered pin so use a good small diameter flat nosed.

Jul 18, Joined Sep 8.

2, Posts. #3 Jul 16, There is a tool, all new cars use it today. Or just remove the tail shaft housing but hold the mid plate and don't. make it move at all or you'll lose all the input shaft needle bearings. You will need to Estimated Reading Time: 2 mins.

May 15, Discussion Starter #1 May 14, Need to remove the tailshaft bushing on a Nash 4+1 trans without removing the trans from the car. Looking to buy/rent the bushing removal tool (Snap on # S).

Anyone have any leads on getting this tool or any other way of removing the bushing. Note this trans uses the large bushing (just under 2 Estimated Reading Time: 1 min.

Apr 30, Bloomington, MN. KD Tools makes a tool for this. (#) (Don't know if it's still available or not. I got one on ebay years ago.) You can use it to pull and replace the tail shaft bushing. Makes it a 5 minute job. maverick said: place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is. Bushing and Seal Remover Alt. This is a high-quality Aftermarket Product. Use this tool to remove the output shaft bushing from 42RE and 46RE automatic transmissions and the output shaft bearing from transfer cases.

Also used on NV, NV, NVGENII, NV,NV and NV Transfer Cases. Are you interested in making your own tools for automatic transmission overhaul?

Execution time: 0.

Look no bushtrim.buzz video covers the fabrication of the bushing removal to. Jun 04, a bushing driver set is the really way to go since it supports the inside as well as the top of the bushing while driving it in. a tranny shop has the right tool to do bushtrim.buzz than 5 minutes it takes.

a puller can be used as the tail is on the tranny and they have a driver to install it. the same as a tranny.i wouldnt use a socket or Estimated Reading Time: 5 mins. Replacing the Muncie Tail shaft bushing without removing transmission or tail shaft housing. Jan 25, Re: Muncie 4spd tailshaft removal. AM - Post# In response to.

There isn't much to removing the tail housing. Just take a small punch and remove the reverse shaft lock pin. It pushes out from the bottom. This is a tapered pin so use a good small diameter flat nosed punch to remove it. Then pull the reverse shift rod out to.